Working distance and field of view size
3
2
1
Figure 6: Field of view
1
Working distance
2
Depth of field
3
Field of view size: horizontal x vertical (mm) in working distance
1
The configured working distance affects the speed of the AGV and the size of the field
of view depending on the mounting alignment and the 2D codes used,
reference values during operation", page 48
Focus setting
The focus position can be manually adjusted to the working distance using the focus
adjustment tool.
The focus position is valid for one working distance. The device does not perform auto‐
matic tracking (auto focus) if, for example, the working distance changes significantly.
NOTE
After successful calibration, do not change the working distance of the device and the
reading distance set in SOPAS ET.
If these settings are changed, the device must be recalibrated.
Further topics
•
Adjusting focus with the focus adjustment tool
5.3.3
Mounting angle
Important information
NOTE
If problems with reflections occur, use a polarizing filter (part number: 2088228),
.
NOTE
Use the latest version of the SOPAS ET configuration software.
Versions older than SOPAS ET Version 2018.04 are not compatible with the device.
MOUNTING
5
8026021/1D2S/2022-09-01 | SICK
O P E R A T I N G I N S T R U C T I O N S | GLS611
21
Subject to change without notice
