SICK 1083009, Инструкция по монтажу

Страница: 12 / 18

5
Status LEDs
6
Additional LEDs for ON state and OFF state
7
Network LEDs
8
Safety laser scanner without system plug
9
System plug
ß
Cover plate
The USB connection (USB 2.0 Mini-B, female connector) may only be used temporarily
and only for configuration and diagnostics.
4 Changing position of the system plug
Changing the position of the system plug: B
The system plug is installed at the bottom when the safety laser scanner is delivered.
You can installed the system plug at the rear, e.g. if there is no room for cables under
the safety laser scanner.
Installing the rear system plug
Tool required:
• TX20 Torx wrench
1. Loosen the screws of the system plug.
2. Carefully remove the system plug from the safety laser scanner.
3. Loosen the screws of the cover plate on the rear side of the safety laser scanner.
4. Remove the cover plate on the rear side of the safety laser scanner.
5. Carefully slide the new system plug into the safety laser scanner at the rear.
6. Screw in the system plug using the captive screws. Tightening torque:
2.25 Nm … 2.75 Nm.
7. Put the cover plate on the bottom of the safety laser scanner and fasten it. Tight‐
ening torque: 2.25 Nm … 2.75 Nm.
5 Mounting the safety laser scanner directly
Direct mounting: C
The safety laser scanner has 4 M5 threaded holes on the back. If you are able to drill
through the mounting surface from the rear, you can mount the safety laser scanner
directly using these threaded holes.
b
Use either the rear
1
or the side
2
M5 threaded holes for direct mounting.
b
Use all four rear or all four side M5 threaded holes for direct mounting, so that the
values given in the data sheet for vibration and shock resistance are achieved.
b
Maximum depth of thread engagement: 7.5 mm.
b
Tightening torque: 4.5 Nm to 5.0 Nm.
MOUNTING INSTRUCTIONS
12 M O U N T I N G I N S T R U C T I O N S | microScan3 – PROFINET (RJ45, SCRJ) 8021229/13IA/2019-05-16 | SICK
Subject to change without notice