Sices HS 315, Техническое руководство

Страница: 97 / 255

Technical Handbook 79
The controller manages a high number of parameters that allow the manufacturer, the installer
or the final user to configure it to adapt it to specific system requirements. This document does
not contain the parameters list (even though many of them are quoted in the description of the
controller functions); the list is available in the document:[1]
where they’re described in detail.
In this document the general programming structure and the operating procedure to read
and/or modify parameters are described.
To access parameters, change mode, scroll with the UP and DOWN buttons to menu P.03-
Programming and press ACK/ENTER to start.
To exit programming menu and to return to the main screen press the ESC/SHIFT button.
WARNING:
assigning an incorrect value to one or more parameters can cause
malfunctions, damage to things or injury to people. The parameters must only be
changed by qualified personnel. Parameters can be password protected (refer to par.
8.5.1.2).
This mode lets you display and change the programming parameters.
Each programming parameter 3 has a 4-digit numeric code (e.g. P.0133) to identify the
variable regardless of the language used. The current value of the parameter is displayed
below the description.
The first line, below the upper status bar, allows to identify the current menu using the ID
number of the menu and the associated text. A pair of numbers is displayed on the right of this
line (2/06 in the example in fig. 3): the first indicates which entry in the menu is selected, the
seconds indicates how many entries can be displayed in the current menu/submenu.
If the password is lost, you can reconfigure it using a higher-level password. Contact
our service centre
if the “MANUFACTURER” password is lost.
The first item (0000-Access Code) of the SYSTEM menu requires setting the access code if
one or several passwords have been assigned (available with the path P.03 PROGRAMMING\
1.SYSTEM\ 1.1 Security\ 1.1.1 Authentication).
Password is not assigned if equal to 0 (only valid for Manufacturer, Installer and User
passwords).
The pages corresponding to password setting are displayed only if you are authorized to make
changes in the SYSTEM sub-menu (with path P.03 PROGRAMMING\ 1.SYSTEM\ 1.1
Security\ 1.1.2 Password).
P.07 PROGRAMMING
1.2 Engine 2/06
0133-Nominal speed
engine (primary)
[1500]
2
3
KEY:
1 - Status bar
2 - Current menu
3 - Current parameter
4 - Parameter value
Fig. 3 - Display areas
1
4