SICE Tech 4791010, Дублирование процедур

Страница: 6 / 10

6
11.0
ROLLING COMPLEX
DUPLICATING PROCEDURES
FAAC
433 - 868
GENIUS
433 - 868
Attention: verify the programming remote control is a MASTER.
Pressing whatever button, the LED has to emit a double flash rather than to switch on as a fixed light.
1.
While pressing the button 1 of the “WHY EVO”, at the same time press 4 times the 2 button.
2.
Release both buttons. Now the WHY EVO RED LED will emit a short flash every 2 seconds.
3.
Place the original remote control to be programmed in front of the “WHY EVO”, at about 1-3 cm of distance.
4.
Press and retain pressed the button to be programmed of the original remote control, till the LED will switch on as a
fix light; now release the button.
5.
The WHY EVO RED LED will emit a short flash every 2 seconds. That it informs the user that, to duplicate the remote
control, it is necessary to emit the SEED CODE to realize the copy.
6.
Predispose the FAAC/GENIUS remote control for the SEED CODE emission. Press at the same time the 1 and 2 buttons
(note: THESE ARE THE BUTTONS OF THE DIAGONAL LINE as in the picture).
7.
While FAAC/GENIUS remote control LED flashes, place it in front of WHY EVO at a distance of 1-3 cm and press the
button to be programmed until the WHY EVO RED LED will change the flash mode (more fast) and a change of its
color (GREEN), for a reconfirmation of the correct code learning. This step may take some seconds.
8.
At this moment, press the button when you want to store the code and retain pressed until the WHY EVO GREEN LED,
switches off.
9.
The copy has been happened with success. Now check on the automation the correct functioning of new WHY EVO
remote control pressing two times the copied button.
Notes:
• If the RED LED flashes only 3 times and switches off, the code has not learnt correctly. Please repeat the operation
from the step 1.
• The WHY EVO memory is completely re-writable.
• To duplicate further buttons of WHY EVO, please repeat the operation from the step 1.