Siborg LCR-Reader MPA, Руководство пользователя

Страница: 19 / 28

© Copyright Siborg Systems Inc.
18
main menu.
7.7 Signal Generator Mode
Only Sine wave signal is generated.
The signal is applied to the device
probes. It is possible to adjust the
span (peak-to-peak) of the signal from 0.1 to 3.0 V. Parameters
are stored when exiting the mode. On the right of the screen the
voltage span and the waveform icon are shown. The frequency in
Hz is displayed in the center of the screen.
In this mode, the turn-off time is 4 times longer than the default
in other modes. An external decoupling capacitor is required to
supply a signal to an active circuit. It should be connected to the
Blue probe. The Red probe is common, virtual ground. In this
mode, the device does not turn-off by "flipping" and the function
of automatic change of the display orientation (left/right hand) is
disabled. It is recommended to use LCR-Reader Kelvin Probe
Connector to simplify the device operation in this mode.
7.7.1 Controls
•
Push the joystick to the left or right for 1 beep to select the
item to change.
•
Push the joystick up/down for 1 beep to increase/decrease the
selected parameter.
•
Push the joystick to the left for 2 beeps to reset the cursor to
the initial position.
7.8 System Menu Entries
7.8.1 Power
Battery Voltage
Turn-off Time: Push joystick Up/Down to Increase/Decrease
Turn-Off Time
Flip Turn-off: Off/On/Exit
Power Save Mode: Off/On/Exit
Exit
7.8.2 Sound
Loud/Moderate/Quiet/Exit
7.8.3 Display
Hand: Right/Left/Auto/Exit
Brightness: Push joystick Up/Down to Increase/Decrease
Brightness
Backlight: Push joystick Up/Down to Increase/Decrease Backlight
Exit