Siborg LCR-Reader MPA, Руководство пользователя

Страница: 12 / 28

11
© Copyright Siborg Systems Inc.
distance of the size of the component and calibrate with open
probes. Only then measure the capacitor.
Before measuring small inductances (less than 10 μ H) and
resistances (less than 10 Ω ) wipe off the tips of any dirt and
oxides and calibrate with short probes.
7.1.5 Capacitance Offset Calibration Board
The Capacitance Offset Calibration Board provides a reliable
method of determining the parasitic offset between the test
leads. The dummy PCB uses holes to represent various sizes of
components.
To use the calibration board, place the test leads into the holes
corresponding to the size of component under test; make open
calibration by pushing the
joystick to the right, hold for 2
beeps and release.
7.2 R-L-C-D mode menu
To open the hidden R-L-C-D mode
settings push the joystick to the right
and hold for 1 beep, the following
menu will appear. The menu tree is
shown in detail in the following
diagram:
7.2.1 Primary Parameter
In Auto mode the type of measured component is determined
automatically: R: Resistor, L: Inductance, C: Capacitor, D: Diode.