siat ProWrap 16_H_FM, Руководство по эксплуатации и обслуживанию

Страница: 30 / 104

Maintenance
IDM 510-129-1
28
English language Operation and maintenance manual
Scheduled maintenance intervals
Always keep the machine in optimum operating condition and carry out the
routine maintenance according to the intervals and procedures specified by
the Manufacturer.
– In case of prolonged inactivity, carry out some maintenance operations in order
to preserve functionality and prevent further damages.
– After prolonged inactivity, carefully check that the operating functionality has re-
mained unaltered.
– A good maintenance will ensure a stable performance over time, longer working
life and constant compliance with the safety requirements.
Maintenance schedule
Every working day
Component Operation required Procedures to implement
Safety devices Checking
- Make sure that the listed devices are efficient.
- Emergency stop button.
- Main electric disconnector
Every 40 work hours (max 1 week)
Component Operation required Procedures to implement
Lifting belt for the reel holding carriage Checking
- Check this component for wear.
- Replace the belt in case it is excessively worn. (See
“Replacing the lifting belt of the carriage”).
Reel holding carriage sliding guides Cleaning
- Remove any impurities with a plastic scraper.
- Clean with a soft cloth soaked in a non-flammable
and non-corrosive detergent.
- Properly dry the surfaces.
Attention
Warning
Do not use water jets.
Load to be wrapped detection photocell Cleaning
- Clean the detection area of the photocell.
- Use a clean, dry (not abrasive) cloth.
Every 2000 work hours (max 6 months)
Component Operation required Procedures to implement
Air filter (if any) Cleaning
- Clean the filter or replace it with an original spare
part, if necessary (See “Cleaning and replacement of
the air filter”).
Rotating platform rotation chain
Checking
- Check the tension of component.
- Adjust tension as required - if necessary (See
“Adjustment of chain controlling the rotation of
platform”).
Lubrication
- Lubricate all the greasing points (See “Diagram of
the points of lubrication”).
Film pre-stretch belt (Only for reel holding
carriages of type PW).
Checking
- Check the tension of component.
- Adjust tension as required - if necessary (See
“Adjustment of drive chain tensioning”).
- Replace the belt in case it is excessively worn.
Film drawing-in rollers (Only for reel
holding carriages of type PW).
Cleaning
- Clean with a soft cloth soaked in a non-flammable
and non-corrosive detergent.
- Properly dry the surfaces.
Attention
Warning
Do not use water jets.