NETWORKS
WE100
4
2. Installing WE100 CPE
STEP 1
Connect one end of an RJ45 Ethernet cable to the LAN OUT port of the PoE
adapter and the other end to LAN of WE100 CPE.
STEP 2
Connect the second RJ45 Ethernet cable attached to the PoE adapter to a network
device, such as to a switch or to the system you use to configure WE100 CPE.
STEP 3
Connect the PoE adapter to the main electrical supply using the power cord
provided with the PoE adapter kit. Now, turn on the power supply. PWR LED on
the back side of the unit glows. This indicates that WE100 CPE is receiving
power through the PoE adapter and that the connection between WE100 CPE
and your network has been established.
i
Note:
In case any LED does not operate, then refer to the
“Quick Troubleshooting”
section.
Congratulations! The installation of WE100 CPE is complete.
WE100 CPE
Pole
PoE Adapter
Switch
Pole
AP25
Computer
