SHURflo ProPack SRS 540, Инструкция по эксплуатации

Страница: 12 / 19

To Change Pump Speeds:
1. Once your ProPack ™ is primed per the procedure on page 9, simply press the master control button once to
advance to the next speed setting.
2. Each time the master control is pressed once, the pump will advance to the next speed setting.
3. When on speed 4, the highest setting, pressing the master control will shut the power off. To turn the power
on again, simply push the master control once, and follow the above steps to advance the speed.
4. The speed may be advanced while the pump is operating with the hand lever squeezed while spraying, or
with the hand lever closed, simply by pressing the master control.
5. The spray tip may be opened to the stream setting or tightened to deliver the desired cone pattern at any of
the speed settings.
Turning the Power Off
1. To turn the power off, simply push the master control button, and hold the button down for two seconds. This
will turn the power off no matter what speed setting the control was set at.
2. After shutting off the power, always relieve the system pressure for safety, by pointing the wand in a safe
direction and squeezing the hand lever on the spray wand for several seconds.
3. After turning the power off and relieving the system pressure, always disconnect the power plug for safety.
Safety Time Out Feature
If left unused for approximately 8-10 minutes, your ProPack ™ will automatically shut the power to the pump off. To
reactivate, simply push the master control button once.
Low Battery Indicator
When the battery in your ProPack ™ needs to be recharged, the pump will automatically shut off and the indicator
lamp will blink.
Because your ProPack ™ has an advanced microprocessor that maintains a steady pump speed as battery charge
level drops, you will not notice the pump slowing as the battery drains. With this in mind and although a single
charge can last for many hours, there is no warning that your battery is near the level at which it will need to be
rehcarged.
It is not necessary to fully deplete the battery before recharging. After any period of use, the battery may be
charged and returned to full capacity without risk of damage or reduction of cycle life.
10