Shure Incorporated
13/20
2.
3.
2.
1.
2.
3.
4.
5.
◦
◦
Press
channel
button to scan for a clear channel
System scans for the channel with the least interference
Synchronize:
Synchronize the transmitter to the receiver by aligning the infrared (IR) ports and pressing the
sync
but-
ton.
Make sure the IR ports are closely aligned
. After a successful sync, the transmitter LED momentarily flashes red
and the receiver
ready
light illuminates.
This wireless system may be affected by RF interference when used in proximity to other wireless devices such as cordless phones, baby monitors, and two-
way radios. For best results, use the scan and sync feature before each use or if you experience problems.
Multiple System Setup
Use the following steps to ensure the best performance when installing multiple wireless systems at the same location.
Turn all receivers
on
and all transmitters
off
.
Turn on any other digital equipment that could cause interference during the performance so it will be detected during the frequency scans in the fol
lowing steps.
Make sure the group number is the same for all receivers (see Manual Group Selection).
Perform a scan using the first receiver.
Turn on the first transmitter and sync it to the receiver.
Repeat for each system.
After syncing each transmitter, leave it on so that scans from the other receivers will not select that channel.
Be sure only one transmitter IR port is exposed when synchronizing each system.