② Audio Outputs
Analog balanced audio outputs connect to an analog device. Set the output level in the
web application
to match the input sensitivity of the analog device.
XLR pin assignments
:
Shield
1
+
2
-
3
Block connector pin assignments:
See front panel labels
③ Chassis Ground Screw
Provides an optional connection for microphone shield wire to chassis ground
Note:
only applies to block connector version
④ LED Indicators
Power:
Power over Ethernet (PoE) present
Note: Note: Use a PoE injector if your network switch does not supply PoE.
Network:
Network connection active
Network Audio:
Dante™ audio present on the network
Note:
Error details are available in the event log in the
web application
.
Encryption:
Not currently supported
Activity
LED Status
No active signal
Off
Device is operating successfully
Green
Error has occurred. See event log for details.
Red
⑤ Dante Network Port
Connects to a network switch to receive Dante™ audio, Power over Ethernet (PoE), and data from the control software.
⑥ Reset Button
Resets the device settings back to the factory default
Installation and Rack Mounting
Two mounting solutions are available for installing the
Audio Network Interface
:
CRT1 19" Rack Tray (optional accessory):
Supports up to 3 devices; mountable in a rack or under a table
Single-unit Mounting Tray (included accessory):
Supports a single device for mounting under a table
Securing the Devices
Use the included screws from the mounting hardware kit to secure the
Audio Network Interfaces
.
Audio Network Interfaces
can be mounted to face either direction.
Insert the screws from the bottom in the appropriate holes, according to the following diagrams:
Shure Incorporated
Microflex Advance ANI4OUT
Microflex Advance ANI4OUT
3/21
2016/08/24