4
Specifications:
This amplifier is a single ended triode Class A 300B integrated amp. It has auto bias
circuit so no manual bias adjustment is required.
Input impedance: 100kohm
Input Power Voltage: ≤350mV
Output Power：2×8W
Output impedance: 4、8Ω
Frequency Response: 12Hz-25KHz
THD: 1%
S/N Ratio：80dB
Power supply：AC 115V 60Hz
Net weight：23 Kg / 51 lbs
Size： 410mm （W）×335mm（D）×210mm（H）
Operational Instructions:
1. Install all tubes to its corresponding sockets securely. Press down gently but ensure a
tight secure connection.
2. Select 4ohm or 8 ohm speaker connectors based on your speakers specification and
connect both channels correctly and securely.
3. Connect RCA interconnects from your source to the amplifier (red to red, black to
black)
4. Connect the provided power cord to the power socket at the rear panel. Use a proper
size 3-prone power cord only if you plan to upgrade the stock power cord.
5. Check the above steps carefully to ensure all connections are secure and correct.
6. Turn the volume knob to minimum, press down“Power” button. The Power LED light
should come on and tube filaments turn on gradually.
7. Wait for 30 seconds, adjust the volume to proper level then you can start to listen to
the music.
8. In 5-10 minutes after power on, the amplifier and the tubes will be preheated and the
