•
Place both instruments on a desk with a distance of approximately 1.5 meter. Avoid getting close to
possible interference sources (Electronic devices and radio installations).
•
Remove the protective foil from the display of the
receiver
.
•
Connect
the
basic
station
to
the
attached
micro-usb wire,and
put
USB
port
into
5V
/
1A
power
part
,
like
computer
,
the
charger
of
phone
,
etc
.
(
This
way
the
backlight
will
be
light
all
time
.)
6.1 Inserting the batteries in the receiver
6. Getting started
-6-
•
Or remove
the
battery
cover
and
insert two new batteries 1,5V AAA,polarity
as
illustrated,Close
the
battery
compartment
again
. (
This
way
the
backlight
will
be
not
light
all
the
time
,
it
need
press
button
to
turn
on
the
backlight
,
and
the
backlight
will
light
few
seconds then auto turn off.)
•
The device will alert you with a beep and all LCD segments will be displayed for a short moment.
•
The
default
:
T
IME:
2019
-
1-1
, 0:00;
AL1: 6:00, OFF ; AL2: 0:00, OFF
Hour system: 24hr; Temperature unit:
°
C;
• The pressure is blinking,press or to adjust the value,press “SET” to confirm and quit;
if no button pressed,then after 20s it will be auto quit the setting and go to RF search.
•
Open the screwed battery compartment of the outdoor transmitter.
•
The slide switch for channel selection is at position 1 (default).
•
Insert two new batteries 1,5 V AAA, polarity as illustrated.
•
Close the battery compartment again.
6.2 Inserting the batteries in the outdoor transmitter
