First line: shows DMX address
Second Line: shows inner temp. and temp. bar, as well as error info if available
Error Information
Error Information
E0 System IC
E2 Temp. Sensor
E3 P Temp. Over
Explanation
Systematic error
Temperature sensor is not connected or damage
Chassis over-temperature
E4 Time Remain
Activated time for machine is not enough, need to swip RFID card
E5 K Temp. Over
Inner core over-temperature
E6 Heat Fail
Heating Fail, if it recovery automatically, problem is shortage of power supply
Setting Menu
Press “MENU” switch through setup menu
Set DMX Address
Fountain Height
Manual firing height setup, for test only
1-512
1-10
Auto Clear Delay
Auto clear material time after each firing
0.1-0.9s
Manual Fountain
On/Off
Set DMX address
If controlled by Host Controller, please set DMX address as
1, 3, 5, 7,…2n-1, otherwise it may leads to signal interference
Manual firing, for test only
3
Main interface
：
> Interface