showtech FUSION QXV, Руководство пользователя

Страница: 9 / 20

9
- 3 - FUNCTIONS AND SETTINGS
3.1 OPERATION
Connect the supplied main cable to a socket (100-240V~/50-60Hz). Then the unit is ready for operation
and can be operated via a DMX controller or it independently performs its show program in succession.
3.2 BASIC
Access control panel functions using the four panel buttons located adjacent to the OLED display.
MENU UP DOWN ENTER
Used to access the menu or
to return a previous menu
option Navigates downwards through
the menu list and increases
the numeric value when in a
function Navigates upwards through
the menu list and decreases
the numeric value when in
a function Used to select and store the
current function value or
option within a menu
UP
ENTER
MENU
DOWN
12
3.4 AUTO SHOW
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its
auto show programs:
• Press the MENU button until the display shows
Auto Show , then press the button ENTER.
• Press the button UP/DOWN to switch between the show ( Auto 1 - 14 ). The unit will operate in show mode.
• Use the UP/DOWN buttons to select the desired run speed slow-fast (1-100) .
• Press the ENTER button to save the setting.
IMPORTANT: Programs Auto 1 - 14 are fully pre-programmed and will not be altered by changes. Instead,
Manual Color mode allows to combine the colors Red - Green - Blue - White .
• Press the button MENU so many times until the display shows Static , then press the button ENTER.
• Through the button UP/DOWN select Manual Color , then press the button ENTER.
• Select the color Red - Green - Blue - White through the buttons UP/DOWN.
• Set the value (000 - 255) , through the buttons UP/DOWN.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.5 STATIC MODE
• To enable the static mode, press MENU repeatedly until
Static
shows on the display.
• Press the button ENTER.
• Through the button UP/DOWN select Fixed Color , then press the button ENTER.
• Select the desired preset color (R - G - B - W - GB - RB - RG - RGB - RW - GW - BW - RGW - RBW - GBW - RGBW) using the
button UP/DOWN.
• Press the button ENTER to save the setting.
• Press the MENU button to go back. Or, after a few seconds, the menu returns to the main screen.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
• Press the button MENU so many times until the display shows
Master/Slave
and press the button ENTER.
• Press UP/DOWN to set the unit as master or slave (Master/Slave) .
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
unit. For longer cable runs, using a DMX terminator as described in this manual is recommended.
3.7 LINKING
master unit.
are connected in a chain.
5-pin