SHOWTEC Wipe Out 360 RGBW, Руководство пользователя

Страница: 19 / 32

18
Ordercode: 42562
Wipe Out 360 RGBW
6. Settings
01) While in the main menu, press the UP and DOWN buttons until the display shows .
02) Press the UP and DOWN buttons to toggle between the following options:
 6.1 BL time
 6.2 Adjust
 6.3 Reset
 6.4 Power
 6.5 Error
 6.6 Lamp
 6.7 Use
 6.8 Sensor
 6.9 About
6.1 Settings – BL Time
01) When the display shows , press the SETUP button to enter the display blackout settings.
02) Press the UP and DOWN buttons to choose one of the following options:
 On (display continuously ON)
 5s (display turns OFF after 5 seconds)
 10s (display turns OFF after 10 seconds)
 20s (display turns OFF after 20 seconds)
 30s (display 30s turns OFF after 30 seconds)
6.2 Settings – Adjust
01) When the display shows , press the SETUP button to enter pan/tilt manual adjustment.
02) When the display shows , press the SETUP button to enter pan adjustment.
03) Press the UP and DOWN buttons to adjust pan. Both, positive and negative values, are possible.
04) When the display shows , press the SETUP button to enter tilt adjustment.
05) Press the UP and DOWN buttons to adjust tilt. Both, positive and negative values, are possible.
6.3 Settings – Reset
01) When the display shows , press the SETUP button to enter the menu.
02) When the display shows , press the SETUP button to run the reset or the MODE button to cancel
the reset.
6.4 Settings – Power
01) When the display shows , press the SETUP button to view the information about the output
power.
02) Press the UP and DOWN buttons to view the information about the main or LED output power.
6.5 Settings – Error
01) When the display shows , press the SETUP button to enter the menu.
02) The device will check for all possible software errors, while displaying current status: .
03) Press the SETUP button to complete the operation. If there were not any errors, the display will show
.
6.6 Settings – Lamp
01) When the display shows , press the SETUP button to view the light output information: .
6.7 Settings – Use
01) When the display shows , press the SETUP button to check for how long the device has already
been used.
02) When you press the SETUP button, the display will show .
03) Press the SETUP button to perform time reset or the MODE button to cancel time reset.