SHOWTEC Star Sky Pro II, Инструкция по эксплуатации

Страница: 13 / 32

12
Ordercode: 40372
Star Sky Pro II
Control Modes
There are 6 modes:
• Built-in programs
• Manual mode (RGB, Group mode)
• Macro mode
• Sound-controlled mode
• Master/Slave
• DMX-512 (7CH, 28CH)
One Star Sky (Built-in programs, Manual mode and Macro mode)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Star Sky is not connected with a DMX cable, it functions as a stand-alone device.
Please read for more information about the Built-in programs (page 22), Manual mode (pages 20-
21) and Macro mode (page 23).
One Star Sky (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Star Sky will react to the beat of the
music. Please see pages 17 (Sound-controlled mode) and 19 (DMX failure) for more information.
Multiple Star Sky devices (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Star Sky.
The pins: 01) Earth
02) Signal -
03) Signal +
03) Link the units as shown in fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 17-23 (Built-in
programs, Manual mode, Macro mode or Sound-controlled mode). This means that you can set
your desired operation mode on the master device and all slave devices will react the same as the
master device. However, the DMX address of the slave devices must be the same as the one of the
master device.
Multiple Star Sky devices (Master/Slave control)
Fig. 04