SHOWTEC Pocket LaserBeam, Руководство пользователя

Страница: 8 / 10

6
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Graphics will be executed after the power switch ( 2 ) is turned on.
Function-Mode ( 1 ) may be selected from Slow, Music or Fast-Mode:
• Slow-Mode: 12 pre-set graphics to be executed in regular order with slower speed.
• Musik-Mode: pre-set graphics to be executed in regular order via the built-in microphone.
• Fast-Mode: 12 pre-set graphics to be executed in regular order with faster speed.
Warning : Always disconnect power from the mains, when device is not used.
Maintenance
The Showtec Pocket LaserBeam requires almost no maintenance. However, you should keep the unit
clean.
Otherwise, the fixture’s light-output will be significantly reduced. Disconnect the mains power supply,
and then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents. Keep connections clean. Disconnect electric power, and then
wipe the connections with a damp cloth. Make sure connections are thoroughly dry before linking equipment
or supplying electric power.
The operator has to make sure that safety-relating and machine-technical installations are to be inspected
by an expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be inspected
by a skilled person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4. The electric power supply cables must not show any damages or material fatigue.
Troubleshooting
No Laser
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the power supply or the lamp.
1. Power supply. Check that the unit is plugged into an appropriate power supply.
2. The Laser. Return the device to your Showtec dealer.