SHOWTEC Phantom 250 Spot, Руководство пользователя

Страница: 20 / 22

18
Problem Probable cause(s) Remedy
One or more
fixtures are
completely dead. No power to the fixture · Check that power is switched on
and cables are plugged in.
Primary fuse blown. · Replace fuse.
Fixtures reset
correctly, but all
respond
erratically or not
at all to the
controller. The controller is not connected. · Connect controller.
3-pin XLR Out of the controller
does not match XLR Out of the first
fixture on the link (i.e. signal is
reversed). · Install a phase reversing cable
between the controller and the first
fixture on the link.
Fixtures reset
correctly, but
some respond
erratically or not
at all to the
controller.
Poor data quality · Check data quality. If much lower
than 100 percent, the problem may
be a bad data link connection, poor
quality or broken cables, missing
termination plug, or a defective
fixture disturbing the link.
Bad data link connection · Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables.
Data link not terminated with 120
Ohm termination plug. · Insert termination plug in output jack
of the last fixture on the link.
Incorrect addressing of the fixtures. · Check address setting.
One of the fixtures is defective and
disturbs data transmission on the
link.
· Bypass one fixture at a time until
normal operation is regained: unplug
both connectors and connect them
directly together.
· Have the defective fixture serviced
by a qualified technician.
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed). · Install a phase-reversing cable
between the fixtures or swap pin 2
and 3 in the fixture, that behaves
erratically.
Shutter closes
suddenly The color wheel, gobo wheel, or a
gobo has lost its index position and
the fixture is resetting the effect. · Contact a technician for servicing if
the problem persists.
No light The power supply settings do not
match local AC voltage and
frequency. · Disconnect fixture. Check settings
and correct if necessary.
Lamp missing or blown · Disconnect fixture and replace lamp.
Lamp cuts out
intermittently.
Fixture is too hot. · Allow fixture to cool.
· Clean fan.
· Make sure air vents at control panel
and front lens are not blocked.
· Turn up the air conditioning.
The power supply settings do not
match local AC voltage and
frequency. · Disconnect fixture. Check settings
and correct if necessary.