6
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
1. Turn the power switch on.
2. Press MENU button for 3 seconds to enter mode setting.
MODE SELECT
press UP / DOWN button to select DMX or MIDI MODE, the matching led
blinks, then press MENU button.
DMX MODE
When DMX led blinks, the 7 segment display shows the blinking DMX initial
address (
A001–A512
), press UP / DOWN button to select desired address
and then press MENU button again.
MIDI MODE
When MIDI led blinks, the 7 segment display shows the blinking channel NO.
(
CH01–CH16
), press UP / DOWN button to select desired channel, press
MENU button again.
HOLD MODE
When the 7 segment display shows ON / OFF, the HOLD led is lit, press UP /
DOWN button to select ON or OFF. If it shows ON, the last scene remains
when DMX disappears; if it shows OFF, the last scene doesn't remain.
SPEED SETTING
Press MENU button once more, the 7 segment display shows
SP01-SP99
,
press UP / DOWN button to select desired chasing speed.
CHANNEL SETTING
Press MENU button, the 7 segment display shows
C-01 – C-72
, select
desired channel using UP / DOWN button, then press MENU button to confirm
and leave mode setting. If you select
C-48
, the 1-48 channel will be executed
periodically in the order.
3. When DMX led is lit, the 7 segment display shows the initial DMX address AXXX, and the 72 channel
DMX signals beginning from the AXXX are converted to 72 channel analogue output. When DMX signal
remains, the Signal led blinks.
4. When MIDI led is lit, the 7 segment display shows MIDI channel NO. (
CH01–CH16
), MIDI signals from
NOTE NO. (22-93) are converted to 72 channel analogue output. When MIDI signal remains, the Signal
led blinks.
5. When it is receiving DMX signal, after the scene setting is finished, press STORE button for 5 seconds till
GOOD
display, now you have stored a scene. Release the button to return to DMX input.
6. Press STORE button to run a pre-stored scene, the 7 segment display shows
STOR
. In mode setting, this
function is defeated.
7. Press CHASE button to enter CHASE mode, the 7 segment display shows
CHAS
.
8. You have three options for analogue output: +(-) 10V, +(-) 12V & +(-) 15V.
Be sure the dip switch 1 is always ON, set dip switch 2 to ON for 15V output, dip switch 3 ON for 12V
output, dip switch 4 ON for 10V output.
Remember any two of dip switches 2, 3 and 4 may not be ON at a time.