SHOWTEC LED Powerline 64, Руководство по эксплуатации продукта

Страница: 9 / 16

7
Installation
Remove all packing materials from the LED Powerline 64 . Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
There are 4 modes: • Stand-alone (built-in programs)
• Sound-controlled
• Master/Slave
• DMX512 (4, 6, 4, 16)
One Powerline ( Built-in Programs )
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Powerline is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 11 for more information about the built-in programs.
One Powerline (Sound-control)
1. Plug the end of the electric mains power cord into a proper electric power supply socket.
2. Turn on the music. If the device is set to sound-control, then the Powerline will react to the beat of the
music. Please see page 11 for more information about the sound-control options .
Multiple Powerlines ( Master/Slave control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Powerline.
The pins:
1. Earth
2. Signal -
3. Signal +
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 11 (Built-in Programs,
or
Music control). This means on the master device you can set your desired operation Mode
and all slave devices will react the same as the master device.
Multiple Powerlines ( Master/Slave control)
Fig. 3