SHOWTEC LED PAR 64 AIRCRAFT, Руководство пользователя

Страница: 13 / 24

12
Ordercode: 30743
LED Par 64 Aircraft
Control Panel
A)
B)
C)
D)
LCD Display
Mode button
Up Button
Down Button
Fig. 04
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Aircraft will respond to the controller.
Please note when you use the controller, the unit has
3 channels.
When using multiple Aircrafts, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Aircrafts should be
1(001) ; the DMX address of the second Aircraft
should be 1+3=4 (004 ); the DMX address of the third Aircraft should be 4+3=7 (007) , etc.
Please, be sure that you don’t have any overlapping channels in order to control each Aircraft correctly.
If two or more Aircrafts are addressed similarly, they will work similarly.
Controlling:
After having addressed all Aircraft fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Aircraft will automatically detect whether DMX 512 data is received or not. If
there is no data received at the DMX-input, the display will show “ NO DMX Signal “.
The problem may be:
The XLR cable from the controller is not connected with the input of the Aircraft.
The controller is switched off or defective, the cable or connector is detective, or the signal wires
are swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
To unlock the display, press and hold any of the 3 menu buttons for 7 seconds. The display will light up
and you are able to change your settings.