SHOWTEC LED Music Tube Controller, Руководство по эксплуатации продукта

Страница: 9 / 15

7
Installation
Remove all packing materials from the LED Tube Basic Controller and the LED Tube. Check that all foam and
plastic padding is removed. Connect all cables.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure proper
transmission on the DMX data link.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Do not connect more than 16 tubes to 1 Power supply. The maximum load current of the power cable is 16A.
If the quantity of tubes exceeds 16, an extra PSU must be added for every 16 tubes.
1)
Test each LED Tube independently before installing. Connect each LED Tube separately to the Psu +
controller ( do not connect the signal cables!). The LED Tube is ok if it lights up in white.
2)
Connect the signal cables of all LED Tubes together. Make sure to fasten the plastic ring well.
3) Connect the mains cables of the LED Tubes together.
4) Test the connection between the controller and ALL LED Tubes. Switch on the controller, press the
MODE button, select TEST MODE and press the SET UP button, the screen will show Connection OK
if tubes are red ? All LED Tubes will be full red if the connection is OK.
5) LED Tube Setting: Press MODE, select ADDRESS MODE and press the SET UP button, the screen will
show Initializing addr Waiting… about 2-3 seconds. The screen will show OK! Address is done once,
thus finishing the setting.
6) Select working mode: Press MODE to select the working mode. Note: Please do as stated above in the 3
steps if you connect the LED Tubes for the first time or reconnect them, otherwise the LED Tubes will
not work correctly.
7)
Installation sample
Each time you use more than 16 LED Tubes, they have to be powered by another power source
otherwise you could blow the main fuse. The External Power Supply output supplies two power
cables with each cable connecting up to a maximum of 8 tubes.
Fig. 6
8) Connect the signal input cable of the first LED Tube to the signal Output connector of the PSU.
Eventually use the optional 5m or 10m extension cables.
9) Connect the mains cable of the first tube to the wall socket.
10) Switch the controller and the PSU on.