SHOWTEC LED BLINDER 2 COB, Руководство пользователя

Страница: 13 / 24

12
Ordercode: 30780
LED Blinder 2 COB
The LED Blinder can be operated with a controller in control mode or without the controller in
stand-alone mode.
Control Panel
A) LCD display
B) MODE button
C) UP button
D) DOWN button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the LED Blinder will respond to the controller.
Please note, when you use the controller, the unit has
4 channels.
When using multiple LED Blinders, make sure you set the DMX addresses right.
Therefore, the DMX address of the first LED Blinder should be
1(001) ; the DMX address of the second LED
Blinder should be 1+4=5 (005 ); the DMX address of the third LED Blinder should be 5+4=9 (009) , etc.
Please, be sure that you do not have any overlapping channels in order to control each LED Blinder
correctly. If two or more LED Blinders are addressed similarly, they will work similarly.
Controlling:
After having addressed all LED Blinder fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the LED Blinder will automatically detect whether DMX 512 data is received or
not.
If there is no data received at the DMX-input, the “
LED “ on the control panel will not flash.
If not, the problem may be:
• The XLR cable from the controller is not connected with the input of the LED Blinder.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.