SHOWTEC EVENTSPOT 60 Q7, Руководство пользователя

Страница: 13 / 36

12
Ordercode: 42727
Eventspot 60 Q7
Control Panel
A).LCD Display
B). MENU button
C).ENTER Button
D).UP Button
E). DOWN Button
Fig.03
DMX Control Mode
The fixtures are individually addressed and connected to the W-DMX transmitter. The W-DMX transmitter is
connected to the DMX controller. The fixtures respond to the DMX signal from the controller.
DMX Addressing
The control panel on the bottom of the fixture allows you to assign the DMX fixture address, which is the
first channel from which the Eventspot will respond to the controller. Please note when you use the
controller, the unit has up to
21 channels (in TR16 mode).
When using multiple Eventspots in TR16 mode , make sure you set the DMX addresses right. Therefore, the
DMX address of the first Eventspot should be 1(d001) ; the DMX address of the second Eventspot should
be 1+21=22 (d022) ; the DMX address of the third Eventspot should be 22+21=43 (d043) , etc. Please, be
sure that you don’t have any overlapping channels in order to control each Eventspot correctly. If two or
more Eventspots are addressed similarly, they will work similarly.
Controlling: After having addressed all Eventspots, you may now start operating these via your lighting
controller.
Note: After switching on, the Eventspot will automatically detect whether DMX 512 data is received or
not. If not, the problem may be:
• The XLR cable from the controller is not connected with the input of the W-DMX transmitter.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Display Off after 30 seconds
When no button is pressed for 30 seconds, the display will turn off.
To light up the display, you have to press one of the buttons: MENU, ENTER, UP or DOWN.
Once you have pressed the buttons, the display will light up.