SHOWTEC EventSpot 1600 Q4, Руководство пользователя

Страница: 14 / 36

13
Ordercode: 44057
EventSpot 1600 Q4 Set
Control Modes
There are 6 modes: ● Manual (stand alone)
● Auto program (stand alone)
● Built-in programs (stand alone)
● Master/Slave
● DMX-512
● Wireless DMX (W-DMX)
One EventSpot (Manual)
When the EventSpot is not connected with a DMX cable and Wireless DMX is switched off, it functions as
a stand-alone device. See page 21 for more information about Manual mode.
One EventSpot (Auto program)
When the EventSpot is not connected with a DMX cable and Wireless DMX is switched off, it functions as
a stand-alone device. See page 21 for more information about Auto program.
One EventSpot (Built-in programs)
When the EventSpot is not connected with a DMX cable and Wireless DMX is switched off, it functions as
a stand-alone device. See pages 21–22 for more information about Built-in programs.
Multiple EventSpots (Master/Slave control)
01)
Use a 3-pin XLR cable to connect the EventSpots and other devices.
The pins: 1. Earth
2. Signal (-)
3. Signal (+)
02)
Link the units as shown in (Fig. 07), connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth units. You can
use the same functions on the master device as described on pages 21–22 (Manual, Auto program
or Built-in programs). This means you can set your desired operation mode on the master device and
all slave devices will react the same as the master device.
Multiple EventSpots
( Master/Slave control)
Fig. 07