SHOWTEC Dreamwave V1, Руководство пользователя

Страница: 10 / 32

9
Ordercode: 43166
Dreamwave
Installation
Remove all packing materials from the Dreamwave. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 5 modes: ● Built-in programs (Show mode)
● Manual
● Sound-controlled
● Master/slave
● DMX-512 (4CH, 8CH, 25CH)
One Dreamwave (Built-in programs, Manual)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Dreamwave is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 16 and 18 for more information about Built-in programs and Manual modes.
One Dreamwave (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Turn on the music. If the device is set to sound-control, then the Dreamwave will react to the beat of
the music. Please see page 16 for more information about the sound-control options.