SHOWTEC dragon 2000, Руководство пользователя

Страница: 15 / 20

14
Ordercode: 61103
Dragon 2000
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens, follow the directions below.
01)
Unplug the unit from electric power source.
02) Insert a screwdriver into the slot in the fuse cover. Gently pry up the fuse cover. The fuse will come
out.
03) Remove the used fuse. If brown or unclear, it is burned out.
04) Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
Always monitor tank liquid level as you are blowing fog. Running a fog machine with no liquid can
permanently damage the unit.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
If the fog machine does not operate properly, refer servicing to a technician.
01)
If you experience low output, mechanical pump noises other than the usual normal operating pump
noise, or no output at all, unplug immediately.
02) Check liquid level, remote connection and power from the wall.
03) If all of the above appears to be O.K., plug the unit in again.
04) If fog does not come out after holding the remote button down for 30 seconds, check the hose
attached to the tank to make sure there is liquid going through the hose.
05) If you are unable to determine the cause of the problem, do not simply continue pushing the remote
button, as this may damage the unit.
06) Return the machine to your Showtec dealer.