For the
Hold
mode, when pushing the fader to the specific channel of the external operator (e.g.
DC-1216
II
), only the adjustment of higher channel value can be held and displayed on the LCD.
Adjustment of lower value will be of no effect in this
Hold
mode.
4.2.1 Barchart display
•
User can use the multi-selector to enter the Barchart display submenu. If there is no signal input,
the LCD will show you empty information like below:
<
RX
Channel
:
000
?
>
001 :
xxxxx
xxxxx
011 : xxxxx xxxxx
021 : xxxxx xxxxx
Each line on the LCD display indicates the values of totally 10 channels. And user can use the
multi-selector to browse and view the values of other channels.
•
If there is an effective input signal to this unit, the LCD will show as the following barchart display:
<
RX Channel : 192
?
>
001 :
011 :
021 :
•
Select the”
?
”, then press the multi-selector for help information, LCD will show you as below:
<
1. Barchart display
chan level
x = no signal
– =
no data
( Each barchart indicates different values )
4.2.2 Value display
•
Value display can be done in three patterns:
Decimal
,
Hexadecimal
or
Percent.
These three
patterns can be selected as user’s requirement in the
Display setting
item (submenu of the
System setup
function mode).
•
Use the multi-selector to enter the
Value display
menu. If there is no effective signal input, the LCD
will show you empty information as below:
<
RX Channel 1 : 000 ?
Start Channel : 001
>
--- --- --- --- ---
>
--- --- --- --- ---
The default channel value is 000 and the start channel is normally 001. To change the start channel,
user can select “
>
” at the right side of the LCD screen, press the multi-selector and then rotate it to
change the channels from 001 to 512. Press the multi-selector again to confirm your setting.
5
