SHOWTEC Compact Lightset MKII, Руководство пользователя

Страница: 13 / 32

12
Ordercode: 30268
Compact Power Lightset MKII
Control Panel
A. LED Display
B. Mode button
C. Setup Button
D. Up Button
E. Down Button
Fig. 04
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the backside of the device allows you to assign the DMX fixture address, which is
the first channel from which the Compact Power Lightset will respond to the controller. Please note when
you use the controller, the unit has up to 15 channels. When using multiple Compact Power Lightsets ,
make sure you set the DMX addresses right. Therefore, the DMX address of the first Compact Power
Lightset should be 1(d001); the DMX address of the second Compact Power Lightset should be 1+15=16
(d016); the DMX address of the third Compact Power Lightset should be 16+15=31 (d031), etc. Please, be
sure that you do not have any overlapping channels in order to control each Compact Power Lightset
correctly. If two or more Compact Power Lightsets are addressed similarly, they will work similarly.
Controlling:
After having addressed all Compact Power Lightsets, you may now start operating these via your lighting
controller.
Note: After switching on, the Compact Power Lightset will automatically detect whether DMX 512 data is
received or not. The problem may be:
●
The XLR cable from the controller is not connected with the input of the Compact Power Lightset.
● The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.