SHOWTEC Beacon 360 V2, Руководство пользователя

Страница: 13 / 28

12
Ordercode: 45051
Beacon 360
Control Panel
A) LCD display
B) ESC button
C) SETUP button
D) UP button
E) DOWN button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Beacon will respond to the controller.
Please note when you use the controller, the unit has
20 channels.
When using multiple Beacons, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Beacon should be
1(001) ; the DMX address of the second Beacon
should be 1+20=21 (021) ; the DMX address of the third Beacon should be 20+20=41 (041) , etc.
Please, make sure that you do not have any overlapping channels in order to control each Beacon
correctly.
If two or more Beacons are addressed similarly, they will work similarly.
Controlling:
After having addressed all Beacon fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Beacon will automatically detect whether DMX-512 data is received or not.
If there is no data received at the DMX-input, the “ LED “ on the control panel will not flash.
The problem may be:
• The XLR cable from the controller is not connected with the input of the Beacon.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.