SHOWTEC 604083, Руководство пользователя

Страница: 9 / 12

8
Ordercode: 604083
Mirrorball Motor up to 30 cm
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice versa.
Connect the device to the main power supply.
Power On
01) Plug the Schuko power cable into the appropriate power supply. The motor will start rotating. The
rotation direction is random.
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The Mirrorball Motor up to 30 cm requires almost no maintenance. However, you should keep the unit
clean.
Please clean internal components once a year with a light brush and vacuum cleaner.
Keep connections clean. Disconnect electric power, and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before supplying electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
If the mirror ball control system does not operate properly, refer servicing to a technician.
Suspect two potential problem areas as: the power supply and the motor.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02) The motor. Return the device to your Showtec dealer.
03) If both of the above appear to be O.K., plug the unit in again.
04) If you are unable to determine the cause of the problem, do not open the Mirrorball Motor, as this
may damage the unit and the warranty will become void.
05) Return the device to your Showtec dealer.