SHOWTEC 42486, Руководство пользователя

Страница: 12 / 19

10
The Studiobeam Tour Q4 LED can be operated with a controller in control mode or without the controller
in stand-alone mode.
Control Panel
Fig. 6
A. LCD Display C. Up Button
B. MODE button D. Down Button
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the
controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the Studiobeam allows you to assign the DMX fixture address, which
is the first channel from which the Studiobeam will respond to the controller.
Please note when you use the controller, the unit has
6 channels.
When using multiple LED Studiobeams, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Studiobeam should be
1(2001) ; the DMX address of the second
Studiobeam should be 1+6=7 (2007 ); the DMX address of the third Studiobeam should be 7+6=13 (2013) ,
etc. Please, be sure that you don’t have any overlapping channels in order to control each Studiobeam
correctly.
If two or more LED Studiobeams are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under ”Addressing’.
Controlling:
After having addressed all Studiobeam fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Studiobeam will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the “ LED “ on the control panel will not flash.
The problem may be:
• The XLR cable from the controller is not connected with the input of the Studiobeam.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.