SHOWTEC 41200, Руководство по эксплуатации продукта

Страница: 7 / 12

5
Installation
Remove all packing materials from the LED Wallpainter . Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
DMX Operation
Press the Up/Down button to change the DMX address setting rnenu:
The DMX Channel functions when using the entire device as one:
Channel 1: Red (0-255)
Channel 2: Green (0-255)
Channel 3: Blue (0-255)
The LED Wallpainter’s built-in controller will automatically detect the presence of a DMX signal.
In order to receive a DMX signal, the built-in controller must be attached to a DMX controller by a 3-pin DMX
cable and the DMX controller must be turned on.
To mix RGB color use channels 1, 2, 3.
Note: When there is no DMX signal, the LED Wallpainter will switch to Stand-alone Mode after a few
seconds.
DMX Addressing
Unit address DMX address
1 1
2 4
3 7
4 10
5 13
6 16
7 19
8 22
9 25
10 28
Etc.