Showgear 100260, Руководство пользователя

Страница: 4 / 12

3
PLB-2246 13-42 LCD Bracket
Product code: 100260
1. Tools required for installing the PLB-2246 13-42 LCD Bracket
● Phillips head screwdriver (200 mm length excluding the handle)
● Power drill + 10 mm masonry (concrete) and 3,2 mm (wood) drill bits for wall installation
● Allen wrench
● Marking pen
● Measuring tape
● Level
2. Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Wood Stud Wall Mounting
● Use a 3,2 mm drill bit (wood) to drill the holes (hole size: 3,2 mm, hole depth: 60 mm).
● Make sure that the supporting surface will safely support the combined load of the equipment and
all attached hardware and components.
● Firmly tighten the woodscrews, but do not overtighten. Overtightening can damage the bracket,
thereby greatly reducing its holding power.
● When mounting the bracket to wood wall studs, make sure that the mounting screws are anchored
into the center of the studs. Use of an “edge to edge” stud finder is highly recommended.
● The provided hardware is for mounting through or attachment to a standard thickness drywall or
plaster into studs. Installers are responsible for providing the hardware for other types of mounting
situations.
Solid Brick and Concrete Block Mounting
● Use a 10 mm drill bit (concrete) to drill the holes (hole size: 10 mm, hole depth: 60 mm).
● When installing the wall mounts on a cinderblock, verify that you have a minimum of 1-3/8” of actual
concrete thickness in the hole to be used for the concrete anchors.
● Do not drill into mortar joints!
● Be sure to mount on a solid part of the block, with a 1” minimum from the side of the block. You
should use an electric drill at low speed to drill the hole, instead of a hammer drill to avoid breaking
out the back of the hole when entering a void or cavity.
● The installer must verify if the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
● Use the wall bracket as a template to mark the holes on the wall.