ShoreTel SA-100, Руководство по установке

Страница: 38 / 84

SA-100 Planning, Installation and Administration Guide Chapter 5: Installing the SA-100
38
To connect the Ethernet ports, do the following:
NOTE
For guaranteed voice quality, we recommend that you connect all ShoreTel
components to an isolated LAN segment.
NOTE
If you are planning to use both Ethernet ports and DHCP, turn the power on
to the unit and let the network assign an IP address to the first port before
you connect the second Ethernet port. This will ensure that the port you
want the SA-100 to use primarily for operation will be correctly identified
by the system.
Step 1
On the back of the unit, locate the GB1 Ethernet jack in the middle of the
panel and plug one end of a Category 5 or higher Ethernet cable into it.
Step 2
Plug the other end of the Ethernet cable into the LAN switch managing
the network segment to which you want connect the SA-100.
•
If you are connecting one cable only, stop here.
•
If you are using DHCP, start the unit and let the network configure it
with an IP address. You can use the process described in “Setting the IP
Address Manually” on page -35 to view the IP address.
Step 3
To implement failover with the unit, plug one end of a Category 5 or
higher Ethernet cable into the GB2 jack on the back of the SA-100 and the
other end into a different LAN segment.
Once network communications are established, LEDs embedded in the Ethernet
ports indicate that the unit is connected to the network and when the unit is
receiving and transmitting data.
5.8 Connecting the Bezel
A locking front bezel and key are included with the SA-100. The bezel contains a
power button and fits over the front panel blocking access to all items installed in
the panel. Refer to the Quick Install Guide shipped with the unit for instruction
about installing and locking the bezel.
5.9 Configuring the Unit for Operation
After you have mounted the SA-100 in a rack and connected it to the network, you
must configure the ShoreTel system to use the unit. ShoreWare Director is used to
configure the ShoreTel system to use the SA-100. The following chapter, Configuring
the SA-100 , describes how to configure the system in ShoreWare Director to use the
SA-100. For information about using ShoreWare Director, refer to the
ShoreTel 12:
System Administration Guide
.
Configuring the system to use the SA-100 also requires IP address information for the
unit. You can use a terminal emulator session to obtain this information from the SA-
100. See “Setting the IP Address Manually” on page -35 for instructions on how to use
a terminal emulator with the SA-100.