ShoreTel SA-100, Руководство по установке

Страница: 35 / 84

Chapter 5: Installing the SA-100 SA-100 Planning, Installation and Administration Guide
ShoreTel 12.3 35
5.5 Setting the IP Address Manually
This section describes how to set the IP address on the SA-100 manually. ShoreTel
recommends that you use a static IP address for the SA-100. You can also use DHCP to
assign the unit an IP address. If you choose to use DHCP, you must configure the
DHCP server with address information for the SA-100 prior to turning on the unit.
You can use the instruction provided in this section to obtain the Ethernet address of
the unit.
NOTE
The SA-100 is shipped from the factory configured to use the DHCP to set
IP address. That means that unless otherwise set, the first time the unit is
turned on with an Ethernet cable connecting it to the network the unit will
seek an IP address from the DHCP server on the network.
To configure the IP address manually, you need the following:
•
Valid IP address for the segment in which you want to install the SA-100.
•
Computer with terminal emulation software installed.
•
Null modem DB-9 serial cable.
Step 1
Connect the DB-9 serial cable to the serial port on the back panel of the
SA-100 and a computer.
Step 2
Hook up the SA-100 power cable and turn the unit and computer on.
NOTE
The SA-100 performs a start-up process when it is turned on. A
sequence of numbers flash on the LED panel during start up, and
a solid LED appears when the process is complete. The process
takes about 30 seconds.
Step 3
On the computer, start a terminal emulation program and set the
following parameters:
•
Baud rate: 19200 bps
•
Data Bits: 8
•
Parity: None
•
Stop Bit: 1
•
Flow control: None
Click
OK
. The terminal screen appears within the computer screen as
shown in Figure 5-1.
Figure 5-1 Terminal Screen