Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028
0004205
Page 6 of 22
Rev 2.7 3/13/2018
Step #5
– Attach Front & Rear Frame Crossmembers
Using the chart, locate the correct length tubes for crossmembers. With the unit still laying on
it’s side, slide the crossmembers over the other corner block leg and insert the short bolt with a
washer into the hole closest to the post and secure on the bottom with a flat washer and brass
lock nut.
DO NOT TIGHTEN.
Step #6
– Complete Frame Corner Assembly
Flip the entire assembly upright onto the base pads.
Locate the long bolts and the bottom corner cable bracket. Insert the long bolt with a flat
washer thru the second hole from the post, thru the frame tubes and then thru the corner cable
bracket on the bottom as shown. Secure with a flat washer and brass lock nut.
Do not tighten.
Note: The leg bundle for the
SSV150144HSDW has stops welded to
the leg tubes and should be used at this
time.
