®
®
InfInIty Dock SyStemS
SHOREMASTER.COM
STEP 6
Leg caps are included for each corner tube that is not used or does
not have a leg post above the deck surface - as shown below.
NOTE: To avoid cracking the press in caps it is best to use a large
rubber mallet to install. Start by lightly tapping around the edges until
the cap is completely fit into the leg pocket.
The leg posts that are above the deck surface may be covered with a
blue cap - as shown below.
Leg Cap
Blue Cap
USE, REMOVAL, STORAGE AND SERVICE
▪
Upon completed installation, your dock system is ready for use.
Many ShoreMaster dock accessories are available to
compliment your dock system
. Contact your dealer for available options.
The dock system must be removed from water during the winter months. Warranty is void if dock is exposed
to ice conditions.
▪
You may remove each frame with panels in place, or you can remove the panels before detaching the frames. Stack panels on
a flat surface, and store them in a dry area to preserve life.
▪
Inspect frames, panels, connections, nuts, and bolts at least once every six months for damage, wear or loose connections.
Tighten or replace parts as needed.
▪
ShoreMaster dealers usually offer service visits. Please contact them if you are unable or unwilling to perform service to docks.
DETAIL A
D
E
A
G
STEP 4
Now the first frame can be carried into place. Place the second
frame into the connector clips of the first - as shown to the right.
To avoid personal injury the connector clips
must be bolted to a dock frame that is supported by legs. The
unsupported end of the attaching dock frame will set into the
connector clip. If the connector clip is bolted to the dock frame
that is not supported by legs the dock section may come loose
and fall, causing injury.
Secure by tightening the 3/8 x 1-1/2 T-Handle - as shown in
Detail "A".
Note:
Two connector clips are needed if connecting to an end
rail. Three are needed if connecting two side rails together.
Supported Frame
Unsupported Frame
Supported Frame
Unsupported Frame
Good Connection
Bad Connection
Connector Clip
Connector Clip
Connector Clip
STEP 5
When all dock frames are in place, adjust the level of the dock
sections as needed using the adjustable leg posts.
Note:
Make sure there is enough clearance for water fluctuation and
wave action.
Fully tighten all Nuts and Bolts.
Note:
Do not over tighten set screws. Over tightening of set screws
will result in bending or breaking of parts.
T-Handle
