11
SECTION TWO
Oxygen Therapy Plus Door Installation - Double Door
The O
2 Door and components are packaged in
separate boxes. Unpack and organize the door
components for assembly and installation.
If equipped, lock all casters on mobile cage banks to
prevent movement during the installation procedures.
Enlist help and USE SAFE LIFTING
PRACTICES during assembly, installation and
moving equipment.
Keep hands clear of possible pinch areas when
assembling parts, which if not avoided, could
result in MINOR to MODERATE INJURY.
STEP 1:
Loosen trim plates, hinges and trim strips. Do NOT remove screws or hardware.
See FIGURE 2.14
STEP 2:
Align the slots on the jamb seal (side) with the hardware screws. Slide the jamb
seal under the trim plates, strips and hardware. Secure the jamb seal with the
center screw, do NOT fully tighten. See FIGURE 2.15
STEP 3:
Repeat STEP 2 for the opposite side jamb seal. See FIGURE 2.16
FIGURE 2.15 - Left Jamb Seal Installation FIGURE 2.16 - Right Jamb Seal Installation
STEP 4:
Align the slots on the head seal (top) with the hardware screws. Slide the head
seal under the trim plates. Secure the head seal by tightening the top trim plate
screws. Do NOT fully tighten. See FIGURE 2.17
STEP 5:
Tighten all trim plates, strips and hardware to secure the jamb and head seals
in place. See FIGURE 2.18
FIGURE 2.17 - Left Head Seal Installation FIGURE 2.18 - Right Head Seal Installation
FIGURE 2.14 - Loosen Hardware
LOOSEN, DO NOT FULLY
REMOVE SCREWS/TRIM
