Mark V 520
Summary Manual
SM - 7
23
24
25
26
27
28 29
30
31
32
33
34
35
36
37
37
39
41
38
40
34. Table Height Lock– Secures the table at any
height.
35. Carriage– Slides along the way tubes and holds
the table support tubes and the lathe tool rest.
36. Carriage Lock– Secures the carriage on the way
tubes.
37. Trunnions– Allows the table to tilt up to 90° left
and 45° right.
38. Table Tie Bar– Supports the table support tubes
and the trunnions.
39. Table Tilt Indicator– This vernier scale indicates
the table angle.
40. Table Tilt Lock– Secures the table at any angle, up
to 90° left and 45° right.
41. Table Stops– When properly adjusted, these bolts
stop the table at 90° left, 45° right and 0°. (Note:
the two 90° table stop bolts are shown.)
The following accessories come with
the Mark V, but are not shown on the
illustrations. Refer to the PARTS
LISTS to identify them.
Sanding Disc– Mounts to the main spindle and is
used for disc sanding.
Drill Chuck and Key– Mounts to the main spindle.
The key locks the bit in the chuck.
Lathe Tool Rest Assembly– Mounts in the car-
riage to support and guide lathe chisels. It has
two mounting positions.
23. Worktable – Holds the stock and provides a
working surface.
24. Table Insert– Used for sawing, sanding, drilling
and boring. It can be replaced with inserts for
dadoing, molding, drum sanding and shaping.
25. Miter Gauge Slots– Guide and secure the miter
gauge.
26. Miter Gauge with Safety Grip– Holds stock firmly
at various angles. It slides freely or locks in the
miter gauge slots.
27. Rip Fence– Mounts to the table and is used as a
guide, support or stop. It automatically aligns
itself parallel to the blade. Holes in the fence are
used to mount fixtures and fence extensions.
28. 10" Saw Blade– Mounts to the 1-1/4" arbor which
then mounts to the main spindle. This saw blade
is use for both crosscutting and ripping.
29. Upper Saw Guard– Provides a physical barrier
between you and the part of the blade above the
table. An anti-kickback mechanism helps con-
trol kickbacks.
30. Lower Saw Guard– Protects you from the part of
the blade or cutter below the table. The saw
guard has a dust chute. The lower saw guard is
also used with the sanding disc.
31. Extension Table– Mounts in either the power
mount or the base mount to provide extra sup-
port for the stock.
32. Table Support Tubes– Support the table above
the bench. Each tube has racks that mesh with
pinions in the carriage to raise and lower the
table.
33. Table Height Crank– Turns the pinions in the
carriage which raise and lower the table.
