ShopBot HandiBot, Руководство пользователя

Страница: 14 / 24

Step 15 — Insert a router bit
Before inserting or changing a router bit, turn off the power switch at the top of the
router.
Use the Keypad to move the router to the center of the work area so you can reach the
yellow spindle lock button. Carefully move the Z down so that the base of the router is just
above the clear dust shield
Flip the Handibot over so that the base plate is facing you.
You may need to loosen the collet nut before inserting a bit. Hold down the spindle lock
(the yellow button shown here) and use the included collet wrench to loosen the nut.
If inserting a V-bit, slide the bit all the way into the collet, then pull it back so that about
1/2" of the shank is exposed. If inserting an end mill bit, insert just until the machining for
the cutting edges starts.
Hold down the spindle lock button and tighten the collet nut.
Use the Keypad to move the router bit up above the base plate before flipping the Handibot
back onto its base.
HandiBot Setup Guide
© 2014 shopbot.dozuki.com Page 12 of 15