To pick up dust and dry material, you must install foam sleeve and reusable
dry filter or disposable filter bag to ensure proper filtration. If the vacuum
has been used to pick up liquids, the foam sleeve must be cleaned and
dried before installing for dry pick up. With tank cover in an upside down
position, slide foam sleeve down over lid cage pulling until foam sleeve
completely covers lid cage
(Figure 11, 12)
. Center the reusable dry filter
(not standard on all models)
on lid cage
(Figure 13)
, slide mounting ring
down over filter until ring is positioned against the ribs of the lid cage
(Figure 14)
. The reusable dry filter should always be in position over the
foam sleeve for dry pick up. To remove the filter for cleaning, remove
mounting ring and filter from lid cage
(Figure 15)
. To clean the reusable dry
filter, shake off excess dirt and dust or (depending on the condition of the
filter) rinse with water. Allow the filter to dry completely and reinstall.
NOTE: ENSURE THAT THE MOUNTING RING IS COMPLETELY SECURE AND IN POSITION BY PRESSING DOWN FIRMLY AROUND THE RING IN
SEVERAL PLACES. BE SURE THE REUSABLE DRY DISC FILTER COMPLETELY COVERS THE FOAM SLEEVE. CHECK TO ENSURE THAT ALL EDGES OF
THE REUSABLE DRY FILTER ARE SECURE UNDER THE MOUNTING RING.
CAUTION -
KEEP FILTER CLEAN.
Efficiency of the vacuum is largely dependent on the filters. Dirty filters will reduce the air flow and efficiency of the filtration system.
DO NOT MACHINE WASH OR DRY.
DRY PICK UP OPERATION
WARNING -
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET BEFORE REMOVING THE
TANK COVER.
11
12
13
14
15
INSTALLING THE FOAM SLEEVE AND DRY FILTER DISC
•
NOT STANDARD ON ALL MODELS
A
B
1
2
3
4
5
6
7
8
9
10
SIDE TANK HANDLE ASSEMBLY
Attach side handles to tank with screws provided.
1. Take axle marked with the letter A and place in dolly also marked with letter A
(Figure 1)
.
2. Take axle marked with the letter B and place in dolly also marked with letter B
(Figure 2)
.
3. Take tool holder and place between axles A and B
(Figure 3)
. Secure with screws provided
(Figure 4)
.
4. Slide rear wheel onto axle A and secure with hub cap provided
(Figure 5,6)
. Repeat with axle B
(Figure 7,8)
.
5. Insert casters into dolly by placing stem of caster into holes provided. Apply pressure and twisting motion until casters snap into place
(Figure 9,10)
. Return tank to upright position.
INSTALLING THE CARTRIDGE FILTER •
NOT STANDARD ON ALL MODELS
WARNING -
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET BEFORE REMOVING
THE TANK COVER.
1. Slide cartridge filter down over lid cage.
2. Place filter retainer on top of cartridge filter. Hold onto base of lid
cage with one hand and turn retainer clockwise to tighten.
3. To remove filter for cleaning, again hold onto base of lid cage with
one hand and turn retainer counter clockwise to loosen.
4. Slide cartridge filter off lid cage.
TIGHTEN
LOOSEN
