Shop-Vac 5761011, Руководство пользователя

Страница: 10 / 36

51. No lubrication is necessary as the motor is equipped
with lifetime lubricated bearings.
PAGE 9
AUTOMATIC SUCTION
SHUT OFF
LUBRICATION
STORAGE
FIGURE 28
FIGURE 29
52. Before storing your
vacuum cleaner the tank
should be emptied and
cleaned. The power cord can
be wrapped around the cord
wraps provided on the tank
cover on rear of unit.
FIGURE 28 .
53. Accessories may be
stored in the tool holder.
FIGURE 29. The vacuum
should be stored indoors.
drain. After the tank is empty, return the drain cap to
its original position. To continue use, plug the cord into
the wall receptacle and turn the unit on. Use side carry
handles for lifting vac when draining tank into drains
that are located above floor level.
50. The vacuum is equipped with an automatic suction
shut-off that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float rises
until it seats itself against a seal at the intake of the
motor, shutting off suction. When this happens, the
motor will develop a higher than normal pitch noise and
the suction is drastically reduced. If this occurs, turn
unit off immediately. Failure to turn unit off after float
rises and shuts off suction will result in extensive
damage to the motor. To continue use, empty the liquid
waste from the tank as outlined in the previous
section.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE
VACUUM COULD LOSE SUCTION. IF THIS OCCURS,
TURN UNIT OFF AND PLACE VAC IN UPRIGHT
POSITION. THIS WILL ALLOW THE FLOAT TO RETURN
TO ITS NORMAL POSITION, AND YOU WILL BE ABLE
TO CONTINUE OPERATION.
NOTE: FOR BEST RESULTS, WHEN VACUUMING,
REMOVE THE BLOWER PORT COVER.