Shop fox W1876, Руководство пользователя

Страница: 15 / 52

Keep. machine. disconnected. from.
power.until.instructed.otherwise.
Figure.4.
Box inventory.
Figure.5.
Hardware and tools inventory.
-13-
Model W1876 (For Machines Mfd. Since 7/20)
SE
TU
P
A
H I
J
K
L
M
N
B
C
D E
F
G
Inventory
Box.Inventory.(Figure.4). Qty
A.
Jointer w/Cutterhead Guard ............................1
B.
Fence ........................................................1
C.
Fence Support Bracket ...................................1
D.
Fence Slide Bracket .......................................1
E.
Dust Port ....................................................1
Hardware.and.Tools.(Figure.5). Qty
F.
Fender Washer 8mm ......................................1
G.
Button Head Cap Screws M6-1 x 16 ....................2
H.
T-Slot Nuts 7, M6-1 ........................................2
I.
Square Nut M8-1.25 .......................................1
J.
Fence Slide Lock Handle .................................1
K.
ON/OFF Paddle Switch Removable Key ................1
L.
Hex Wrenches 2.5, 4mm ............................1 Ea.
M.
T-Handle Torx Wrench T-25 ..............................1
N.
Push Blocks .................................................2
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note: If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.