-46-
Model W1864/W1865 (For Machines Mfd. Since 02/19)
SE
RV
IC
E
10..
Loosen jam nuts and set screws on each side of
infeed roller (see
Figure.54
).
11..
Using a feeler gauge, adjust set screw so it is 0.040"
from roller bushing block (see
Figure.54
), then
tighten jam nut. Repeat on other side of infeed
roller.
12..
Repeat
Steps.10–11
with outfeed roller, only adjust
the gaps to 0.020".
Figure.54..
Example of feeler gauge
location for adjusting infeed roller height
when using wood blocks (one of two
locations shown).
Roller
Bushing
Block
Jam Nut
& Set Screw
Insert Feeler
Gauge Here
13..
Loosen jam nuts and set screws on each side of chip
breaker (see
Figure.55
).
14..
Using a feeler gauge, adjust set screw so it is 0.040"
from cross bar (see
Figure.55
), then tighten jam
nut. Repeat on other side of chip breaker.
15..
Re-install belt cover, top cover, drive chain cover,
and dust port.
Cross Bar
Jam Nut &
Set Screw
Insert
Feeler
Gauge
Here
Figure.55..
Example of feeler gauge
locations for adjusting chip breaker height
when using wood blocks.
6..
Remove dust port, top cover, belt cover, and drive
chain cover.
7..
Raise table until wood blocks get close to
cutterhead.
8..
Use belt to rotate cutterhead and continue raising
table until blocks just barely touch cutterhead
knife/insert at its lowest point of rotation (BDC).
9..
Lock table in place. Upward pressure of wood blocks
will be holding infeed and outfeed rollers, chip
breaker, and pressure bar at same level as knife/
insert at BDC.
Содержание W1864
Страница 73: ...Model W1864 W1865 For Machines Mfd Since 02 19...
Страница 76: ......