-36-
Model W1842 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Moulding.Operation
Removing. more. than.
1
⁄
8
". off. overall.
profile. of. moulding. can. break. knives,.
resulting.in.serious.damage.or.injury.
Max..Profile.Depth.Moulding..............................
3
⁄
4
"
Max..Profile.Width.Moulding........................... 4
9
⁄
16
"
The maximum depth of a moulding cut in soft wood is
3
⁄
4
". For hard or knotty wood, the maximum depth of cut
must be less, and the feed rate may have to be reduced.
If both of these options are not enough, then a table
saw can be used to rabbet out some of the material the
knives would have had to remove. See
Figure.37
on
Page.
39
for an example of this.
To.perform.moulding.operations,.do.these.steps:
1. Plane stock to within
1
⁄
16
" of final thickness. Cut
width to within
1
⁄
8
" of final profile if both edges are
trimmed by knives. Cut to final width if only face is
profiled.
2..
DISCONNECT MACHINE FROM POWER!
3.
Review
Workpiece.Inspection.
(refer to
Page.23
) and
.
Moulding.Do's.&.Dont's.
on
Page.38
.
4. Align fence rails with edges of profile knives.
5.
Put on safety glasses or face shield, a respirator, and
ear protection.
6. Turn planer/moulder
ON
. Stand to side and feed a
test piece into planer/moulder.
7.
Raise table until test piece feeds smoothly into
planer/moulder.
8.
Support infeed end of board until half of board has
been fed into planer/moulder, then walk around to
outfeed side and support other end of board.
9.
Run all moulding through planer/moulder at this
table height.
10.
Raise table and run all moulding through planer/
moulder again. You should be able to cut profile in
2-3 passes depending on type of wood and profile of
cutter.
• Always stand to one side of the
machine—rather than directly
behind the workpiece.
• Always check and reset outfeed
roller height after changing knives.
• Always cut mouldings WITH the
grain direction. Never cut across
the grain or on the end-grain.
• Use roller stands to support long
workpieces.
• Carefully inspect all stock to make
sure it is free of large knots and
foreign objects.
AVOIDING KICKBACK!
Содержание W1842
Страница 65: ...Model W1842 For Machines Mfd Since 6 17...
Страница 68: ......
