Shop fox W1772, Руководство пользователя

Страница: 24 / 72

-22-
W1772/W1773 37" Drum Sander
SE
T
U
P
Recommended.
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables
involved with shipping, some of these adjust-
ments may need to be repeated to ensure opti-
mum results. Keep this in mind as you start to
use your new drum sander.
Step-by-step.instructions.for.these.adjust-
ments.can.be.found.in.SERVICE.
1. V-Belt Tension ( Page.31 ). Perform after the
first 16 hours.
2.
Conveyor Tensioning & Tracking (
Page.34
).
3.
Drum Adjustments (
Page.36
).
4.
Pressure Roller Height (
Page.40
).
— If the top of the conveyor belt rotates
toward the front of the machine, it is
moving in the wrong direction. Stop the
machine, shut OFF the power source,
then swap the incoming power L1 and L3
wires at the junction box (see
Figure. 22)
to correct the conveyor belt rotation.
6.
Press the CONVEYOR STOP button to stop
the machine.
7.
Press the SANDING DRUMS START and
SANDING DRUMS STOP buttons. The sanding
drums should start, run, and stop smoothly.
8.
Press the EMERGENCY STOP button to stop
the machine.
9. WITHOUT resetting the switch, press the
CONVEYOR START button. The machine
should not start.
— If the machine does not start, the
EMERGENCY STOP button safety feature is
working correctly.
— If the machine DOES start (with the
EMERGENCY STOP button pushed in),
immediately disconnect power to the
machine.
The STOP button safety feature is not
working correctly. This safety feature
must work properly before proceeding
with regular operations. Call Tech Support
for help.
10..
Reset the EMERGENCY STOP button.
11.
Press the CONVEYOR START button, then
press the emergency stop bar. The sander
will come to a complete stop. The stop bar
should only be used during emergencies.
The emergency stop bar switch will wear
quicker if this feature is used for regular
shut down.
— If the conveyor belt does not come to a
complete stop, the emergency stop bar
is not working correctly, immediately dis-
connect power to the machine and call
Tech Support for help.
Figure. 22 . Swap L1 and L3 wires at incoming
power junction box.
Swap These Connections