Shop fox W1742SW, Руководство пользователя

Страница: 28 / 72

-26-
O
PE
R
ATIO
NS
W1742W, W1742SW, W1754W, W1754SW (Mfd. Since 9/15)
Depth.of.Cut
Table.Movement.per.Handwheel.Revolution
One Full Revolution .........................................
1
⁄
16
"
The depth of cut on a planer means the amount of
material that is removed from the top of the workpiece as
it passes underneath the cutterhead.
The depth of cut is set by adjusting the distance of
the table below the cutterhead. This distance is the
thickness of the workpiece minus the depth of cut. The
planing depth of cut is controlled by using the table
height handwheel on the right side of the machine (see
Figure.23 ). Rotating the handwheel clockwise raises the
table.
Although the correct depth of cut varies according to
wood hardness and workpiece width, we recommend the
maximum depth of cut (per pass) be no more than
1
⁄
16
".
A series of light cuts will give better end results and put
less stress on the planer than trying to take off too much
material in a single pass.
The depth of cut can be referenced directly from the
table height scale on the front of the planer, as shown in
Figure.23 . The range of material thickness that can be
planed is 3⁄16"–8".
Note:.
The scale functions as a general guide only, and is
not intended for low-tolerance, precision results.
Figure.23.
Location of table height
handwheel, indicator, and scale.
Table
Height
Handwheel
Table
Height
Indicator
& Scale