Shop fox SHOP FOX W1754, Руководство по вставке

Страница: 28 / 69

-14-
W1754 20" Planer With Mobile Base
SE
T
U
P
Before starting your machine for the first time, make
sure the gearbox has oil. The proper oil level is just even
with the bottom of the fill plug hole. The gearbox uses
80W-90W automotive grade gear oil.
To check the gearbox oil level, do these steps :
1. Wipe the outside of the fill plug clean.
2. Using a 6mm hex wrench, remove the gearbox fill
plug (
Figure 10
).
3.
Using the short end of the hex wrench (make sure it
is CLEAN), dip it inside the fill hole and remove it.
(Do not drop the wrench into the gearbox!)
— If the end of the hex wrench is coated with oil,
then the gearbox oil level is okay. Replace the fill
plug and continue with set up.
— If the end of the hex wrench is not coated with
oil, then fill the gearbox with 80-90W gear oil
until the oil reaches the top of the fill plug.
Note: Replace the gearbox oil after the first 20
hours of operation. This is a normal break-in pro-
cedure. See Lubrication on Page 25 .
Gearbox Oil Level
Figure 10. Gearbox fill plug location.
Connecting to Power
Make sure you have read and followed precautions listed
on Page 8 , before connecting your planer to power. The
POWER button and STOP button (
Figure 11
) should illumi-
nate when the planer is connected to the power. Refer to
Page 40
to troubleshoot any problems.
4.
Mount the foot pedal onto the caster and insert the
pin between the two parts.
5. Lock the caster and pedal in place with the E-clip and
washers, as shown in Figure 9 .
�
Figure 9
. Foot pedal and caster
assembled.
Foot Pedal
Caster
Pin
Bracket
Hex Bolt
Figure 11
. W1754 control panel.